When Zhangjiagang full auto tube cutting machine should be stopped in time while performs operations?
We all know that the Zhangjiagang tube cutting machine is well-known in the cutting industry, especially automatic tube cutting machines, semi-automatic tube cutting machines and manual tube cutting machines. During the operation and use, in order to ensure the safety of employees, it is often necessary to shut down the processing. Here we made a summary of the situations in which the Zhangjiagang automatic tube cutting machine should be shut down in a timely manner in order to perform certain operations. I hope it can help you. !
A. It is necessary to stop the tool when replacing the Zhangjiagang fully automatic pipe cutter
When the tube cutting machine is in use, the equipment is in a process of high speed operation. If it is considered that the tool is not easy to use, the tool needs to be replaced. Then it is necessary to close the pipe cutter in time before starting the tool change. Make sure that the cutter is not in use and then turn on the pipe cutter afterwards. Then try to run it. If you feel that there is no problem with the forward and backward operation, try again. If you switch the cutting tool without switching off the tube cutting machine equipment, you will undoubtedly be joking about your life.
Second, when measuring the workpiece needs to be closed Zhangjiagang automatic tube cutting machine
When you need to measure the workpiece operation, you must remember to shut down first. Because the tube cutting machine is still in the process of high-speed operation when measuring the workpiece, then there is not only a safety risk, but also the measurement is not accurate. Therefore, the need to measure the workpiece must be promptly closed after the cutting machine to avoid adverse conditions.
Third, the need to turn off the Zhangjiagang automatic tube cutting machine
When the pipe cutter is used for a long time, the loss of lubricating oil will be relatively large, and at this time we need to add lubricant to the equipment. However, if the pipe cutter is to be lubricated, the pipe cutter must be turned off before starting operation. If the pipe cutter starts to be filled with lubricants during operation, it will not only cause the lubricant to fly outside, but also cause safety accidents. Therefore, when the lubricating treatment of the tube cutting machine is also required, the tube cutting machine equipment needs to be closed in time.
Fourth, the need to close the Zhangjiagang automatic tube cutting machine when cleaning the tube cutting machine head
The head of the pipe cutter will have a lot of debris or grease after long hours of operation. Therefore, in order to ensure the effectiveness of the tube cutting machine, we must remember to regularly clean the tube cutting machine head. However, when cleaning the head of the tube cutting machine, it must be stopped. If the equipment is still in operation, it is very dangerous to start cleaning the pipe cutter head.
Occasionally, our employees may forget the shutdown during the operation of the Zhangjiagang full auto tube cutting machine. To address this issue, Longxin Machinery's new generation of intelligent automatic tube cutting machines have increased the replacement of saw blades and shutdown reminding functions in terms of safety and intelligence. More humane, so cut the tube more simple, more efficient, more secure!
